Merge upstream libdivecomputer changes as requested by Jan Mulder.
"DiveSystem iX3M:
- Add support for new iX3M models
- Add support for new iX3M APOS4 firmware
- Add iX3M firmware version to the devinfo event (ix3m)
Shearwater:
- Report the ppO2 in external O2 sensor mode only (Shearwater)
- Replace the constant offset with a scaling factor (Shearwater)
- Apply the calibration correction only for the Predator
- Report individual sensor values
- Predator: don't report PPO2 unless in CC mode
Misc:
- Fix Sherwood Wisdom 3 memory layout
- Implement read and write functions for OSTC3
- Add support for Mares Quad
- Fix uwatec handshaking error handling"
* 'master' of git://git.libdivecomputer.org/libdivecomputer:
Add support for the new models
Add support for the new iX3M APOS4 firmware
Add the firmware version to the devinfo event
Report the ppO2 in external O2 sensor mode only
Replace the constant offset with a scaling factor
Apply the calibration correction only for the Predator
shearwater: Report individual sensor values
Predator: don't report PPO2 unless in CC mode
Fix the Sherwood Wisdom 3 memory layout
Implement the read and write functions for the OSTC3
Don't ignore handshaking errors
Add support for the Mares Quad
The calibration values for the Petrel are typically in the range 1600 to
2400, while for Predator they are much smaller, with values in the range
800 to 1400. The consequence is that the calculated ppO2 values are too
low for the Predator. Adding a constant offset of about 1000 changes the
calibration value to be in approximately the same range as the Petrel,
and hence more reasonable ppO2 values. But this correction should only
be applied for the Predator, and not the Petrel.
Reviewed-by: Anton Lundin <glance@acc.umu.se>
Merge upstream libdivecomputer changes from Jef Driesen.
The most noticeable part is Jen Mulder's OSTC3 initial setpoint
addition, which fixes the OSTC3 data in CCR3 mode.
But also various cleanups and fixups from Jef.
* 'master' of git://git.libdivecomputer.org/libdivecomputer:
OSTC3: set initial setpoint in profile data
Remove unused parameters
Cleanup the extract dives functions
Remove unnecessary helper functions
Remove deprecated functions from the public api
Remove unnecessary include statements
Fix the firmware version and serial number
Add support for the Uwatec Aladin Tec 3G
After being removed from the public api, these functions can be changed
into local, static functions. And in a few cases, they are no longer
necessary and can be removed completely.
The vendor_product_parser_create() and vendor_product_device_open()
functions should be called indirectly, through the generic
dc_device_open() and dc_parser_new() functions. And the
vendor_product_extract_dives() functions are internal functions that
should never have been part of the public api in the first place.
